Home > Enclosures > Track Style Enclosure >

Custom No Velcro Sunbrella Track Enclousre, Fairplay ZX 2007 & newer
Custom No Velcro Sunbrella Track Enclousre, Fairplay ZX 2007 & newer

Click here for sunbrella colors
List Price: $600.00
Our Price: $513.00
Savings: $87.00

Product Code: FPTE

Cart Year:

Valance Color*:

Side & CP Color*:

Zipper Option*:

Strap w/ hook

See Sunbrella Colors

2 sided w/ ultra seal cold curtain & club protector

Note: Normal shipping time is approximately 2 weeks! Certain times of the year shipping can be up to 4 weeks.

This Sunbrella Track Enclosure comes fully loaded with Ultra Seal Cold Curtain and RainGuard club protector.
*All panels roll up and snap under the valance when not in use. Requires installation of metal tracks on underside of cart top which are included.

  • Note that the entire enclosure must be a solid color except the valance. The valance is the only part of the enclosure that can be a stripe but it can also be a solid color.

"Sleeve Installation"

1. If the car has a windshield, remove it from the golf car.

2. This step is for 82-99 Club Car. Remove the bolt that holds the support arm onto the windshield frame.

2. This step is for E-Z-GO golf carts 94 and newer & Fairplay: Remove any bolts that run through the front windshield supports that provide support or attach windshield.

3. Wrap the sleeve around the windshield frame so that the cut out for the windshield retention clip is in the proper position.

4. Engage the smaller zipper so that it wraps snugly around the windshield frame. An easy way as these sleeves are designed to fit snugly, is to start zipping in the middle of the frame and slide the sleeve up as you zip down. The zipper should be on the back side of the windshield frame.

5. Attach the sleeve to the enclosure, adjusting the height of the sleeve as necessary, for even alignment with the enclosure zipper.

6. With a knife or razor, cut a small "X" in the sleeve to allow for replacement of any supports or bolts if so equipped through the windshield frame and sleeve.

7. Attach the windshield by carefully snapping the windshield brackets around sleeve and frame.

Share your knowledge of this product. Be the first to write a review »