Home > Enclosures >

Custom No-velco Vinyl Track Enclosure, Yamaha
Custom No-velco Vinyl Track Enclosure, Yamaha


 
List Price: $320.00
Our Price: $250.95
Savings: $69.05


Product Code: YVTRACKENC


Type*:
2 sided with Rear Bag Curtain
2 sided with Cold Curtain [Add $50.00]
2 sided with Cold Curtain & Club Protector [Add $148.00]

Cart Type*:
  

Color*:
White
Off-white
Beige
Black
Burgundy

Option*:
Snap
Strap

Qty:  
Description
 

Note: Normal shipping time is approximately 3 weeks! Certain times of the year shipping can be up to 6 weeks.

Vinyl Track enclosures are available in 3 different configurations; descriptions are:

Cold Curtain: The rear (track) closure that comes down from the back of the top and connects with velcro between the rear of the front seat back and the sweater basket leaving the bagwell open but enclosing the cab of the cart. This configuration is usually used in conjunction with a Club Protector and allows sealing the cab in order to use a heater during cold weather.

Rear cover: A rear track closure that covers the bagwell.

OPTIONS:

2-sided with Rear Cover: The tracks cover the driver and passenger sides and the bag area, the rear cover pulls down to cover the bagwell. (Rolls up and snaps under the valance when not in use)

2-sided with Cold Curtain: Same as above except has cold curtain instead of rear cover.

2-sided with Cold Curtain and Club Protector: Covers both sides, also has Cold Curtain in back and allows Club Protector to be let down to protect bag area when needed.

*All panels roll up and snap under the valance when not in use. Requires installation of metal tracks on underside of cart top which are included.

Custom made Vinyl enclosures are custom made for you at the time of order and returns are not accepted except for defects which will be fixed or replaced at the manafacturer's option. These enclosures are for standard factory carts with standard equipment. Please ensure you order for the right year and make of golf cart.


"Sleeve Installation"
1. If the car has a windshield, remove it from the golf car.
2. Remove any bolts that run through the front windshield supports that provide support or attach windshield.
3. Wrap the sleeve around the windshield frame so that the cut out for the windshield retention clip is in the proper position.
4. Engage the smaller zipper so that it wraps snugly around the windshield frame. An easy way as these sleeves are designed to fit snugly, is to start zipping in the middle of the frame and slide the sleeve up as you zip down. The zipper should be on the back side of the windshield frame.
5. Attach the sleeve to the enclosure, adjusting the height of the sleeve as necessary, for even alignment with the enclosure zipper.
6. With a knife or razor, cut a small "X" in the sleeve to allow for replacement of any supports or bolts if so equipped through the windshield frame and sleeve.
7. Attach the windshield by carefully snapping the windshield brackets around sleeve and frame.

Share your knowledge of this product. Be the first to write a review »